(Notice: This labsim is only used for CCNA Voice 640-460)
Question
This task requires you to access the Cisco Unified Communications 500 Series GUI to configure it per the given requirements as stated in the scenario.
From the choices on the left you may select Scenario, Cisco Unified Communications Server (CUC) Device, or Topology. The Scenario link provides the details of the task to be accomplished. The Topology link displays the network. To get access to UC500, click on the PC shown in the Topology or you can click on the CUC Device button on the left.
Scenario:
You have been asked to implement an SBCA solution for a startup company that has two technical support staff. The lP Phones use 4 digit extensions starting with 5001. Using the information in tables 1 and 2, configure the following:
1. Configure the AA & Voicemail features
2. Add the two IP Phones with extensions/users given in table 2 including Voicemail.
3. Configure Hunt Group so that all incoming PSTN calls always go to extension 5001. If extension 5001 is not available, route the call to extension 5002. If both extensions are busy or unavailable then send the call to Voicemail.
Table 1
| Username |
Cisco |
| Password |
Cisco |
| Voicemail |
5111 |
| Auto Attendant |
5000 |
| Hunt Group Pilot |
5010 |
Table 2
| Phone |
Primary Ext. |
LastName |
FirstName |
UserID |
| 00115C0E5EDA |
5001 (Phone1) |
Doe |
John |
Jdoe |
| 003094C3D18C |
5002 (Phone2) |
Brown |
Jane |
jbrown |
Answer and Explanation
Read more…
(Notice: This labsim is only used for CCNA Voice 640-460)
Question
To configure the Cisco Unified Communications Manager Express click on the console host icon that is connected to a Cisco Unified Communications Manager Express by a serial console cable (shown in the diagram as a dashed black line). You can click on the buttons below to view the different windows. Each of the windows can be minimized by clicking on the [-]. You can also reposition a window by dragging it by the title bar.
The “Tab” key and most commands that use the “Control” or “Escape” keys are not supported and not necessary to complete this simulation. The help command does not display all commands of the help system.
Scenario:
You are required to manually configure a Cisco Unified Unified Communications Manager Express to support two IP phones with directory numbers starting with 5001.
The phones need to be configured as dual-line phones as per the following table:
| Phone |
MAC Address |
Primary Directory
Number (dual-line)
Button 1 |
Shared Directory
Number (dual-line)
Button 2 |
| IP Phone 1 |
0014.1CBC.E179 |
5001 |
5010 |
| IP Phone 2 |
0003.E3C4.463C |
5002 |
5010 |
The Cisco Unified Communications Manager Express should be configured as a DHCP and TFTP server.
The IP phones should obtain their IP addresses via DHCP in the range 10.3.130.10 – 10.3.130.254. IP addresses in the range 10.3.130.1 to 10.3.130.9 should be excluded.
The IP phones are connected to an EtherSwitch module, interface GigabitEthernet1/0 on a Cisco 2811 router as per the topology diagram. The voice VLAN ID is 130 and default router for the IP phones is 10.3.130.1.
The EtherSwitch module has been preconfigured and is not configurable.
You are also required to configure a second directory number 5010 as a shared directory number on line 2 of each IP phone.
Topology:
Answer and Explanation
Read more…